Fitting Your TopFlap 

When you get yours, how about fitting it?

 

You will receive two sets of fittings, the flap will be snug with one, but use both to eliminate any rotation of the flap.  In the picture below, is one set of fittings. 


 

The two washers create a secure hole for the plastic rivet to expand around.

4mm holes will need to be drilled.  

The washers go either side of the flap and mudguard, one on the outside:

 The fittings have a low profile, but we recommend a minimum clearance of 6mm between the tyre and inner surface of the mudguard.  This is not normally a problem for mudguards with adjustable stays.

And a washer on the inside:

Web Design by

© 2016 TopFlaps